>> Home >> Magazine >> This page

>> 500+ other articles are available in our archive

 

Tech Tips

Keeping Your Airbrush Shiny and Clean

n by Michael Gleffe
n English translation by Martin Waligorski



Without a doubt, the least interesting and sometimes bothersome aspect of airbrushing is cleaning the equipment. Neglecting to clean a brush properly is the most certain way of assuring yourself of never-ending frustration while painting. Often, thorough cleaning alone may solve a problem.

Most manufacturers would advise you to end your airbrushing session by running pure thinner through your brush, disassembling it and soaking or rinsing the parts in appropriate thinners. While these procedures usually provide adequate cleaning when changing colours, I found them less than satisfactory after a full day of airbrushing.

How do you keep your airbrush as clean as new?

Here is my way of thorough cleaning of an airbrush. It applies to all-metal, double-action types. I use this method once every few days, or when I know that I won't be using an airbrush for a while. I usually spray acrylics in my brush and therefore can use isopropyl alcohol as cleaning medium; for oils or resin-based acrylics use other appropriate thinners.

The key to proper cleaning is removing all paint residue from the internal parts of the equipment, including particularly hard-to-get areas such as the bodywork, connecting threads, paint caps and delicate items such as nozzle and needle. Some brushes may be easier to keep clean than others, but  not attended to they will invariably start to collect paint in confined places, typically  in the nozzle, all threaded connectors and needle aperture in the body.

The procedure is as follows:

  • Run some pure isopropyl alcohol (or other acrylic thinner) through the brush
     
  • Disassemble the brush and wipe the needle and nozzle gently with paper or rag soaked in ethyl acetate
     
  • Now take some household silver polishing compound (Häxan in Sweden) and use it to clean the parts externally and internally. Silver polish is most likely to dissolve any residue that remained unaffected by alcohol or ethyl acetate. All cleaning and polishing must be done gently and carefully. Suitable cleaning tools are:
    • Cotton swabs
    • Go-between dental brushes
    • Cotton makeup pads
    The general principle is to rub and polish the parts externally and internally until no more black oxidized residue remains an a clean cotton swab or pad.
     
  • The last step is rinsing the parts thoroughly with lukewarm water and letting them dry.

The result is shown on the picture.

The advantage of using silver polishing compound is not only restoring the factory-new shine to the parts, but also that the parts will move more smoothly after assembly and that there is less tendency for paint to stick, for example on the needle.

Perhaps a word of caution is also in place, remember that polishing compound contains an abrasive, so applying lot of pressure during polishing could (just maybe) lead to parts wearing off over time. However, I have had my Badgers 175 and 200 for over two years now and didn't notice any negative effects of my cleaning technique. Anyway, always remember to be very gentle with the nozzle!

n


This page: 
Has been last updated:
The URL of the page is:
Downloaded at:


©  Copyright 1997-2006 by IPMS Stockholm and the Community Members. All Rights Reserved.
The layout and graphics of this site, HTML and program code are © Copyright 1997-2006 Martin Waligorski. Used by permission.

Terms of use: This site is an interactive community of enthusiasts interested in the art of scale modelling of aircraft, armor, figures, spacecraft and similar subjetcs. All material within this site is protected under copyright, and may only be reproduced for personal use. You must  contact the Author(s) and/or Editor for permission to use any material on this site for any purpose other than private use.